Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
wb2nb_setup [2015/03/21 21:43]
shelgame
wb2nb_setup [2015/03/21 21:45] (current)
shelgame
Line 14: Line 14:
     * {{::​wb2nb_afrtable.jpg|}}     * {{::​wb2nb_afrtable.jpg|}}
   * You should not need to adjust the **WidebandAFRToO2TransferFunction** table. This table transfers the WB AFR input by the WB sensor/​controller into a NB-type signal.   * You should not need to adjust the **WidebandAFRToO2TransferFunction** table. This table transfers the WB AFR input by the WB sensor/​controller into a NB-type signal.
-  * Finally, you can configure the NB Offset. This value is used to shift the NB signal by a set voltage. This is useful as a simple way to make a given calibration run richer or leaner in closed loop. It will have no effect on open-loop (IE, WOT) operation since the NB signal is ignored during open-loop.+  * Finally, you can configure the NB Offset. Adjustment of this table is completely optional. This value is used to shift the NB signal by a set voltage. This is useful as a simple way to make a given calibration run richer or leaner in closed loop. It will have no effect on open-loop (IE, WOT) operation since the NB signal is ignored during open-loop. ​
     * {{::​wb2nb_afroffset.jpg|}} ​     * {{::​wb2nb_afroffset.jpg|}} ​